Hello!
I not familiar with joints...
I see that joints have hard limits..
http://youtu.be/OoASJWu7P74
It is possible to make springs?
making a worm
Moderators: Sascha Willems, walaber
2 posts
• Page 1 of 1
Re: making a worm
by Julio Jerez » Fri Oct 25, 2013 4:54 pm
are you using teh cutom joints, if so you can you set change the stiffness to make it.
by defualt is 1.0 which make them hard, but but playing with the values you can make soft on the desired degree of freedom
by defualt is 1.0 which make them hard, but but playing with the values you can make soft on the desired degree of freedom
- Julio Jerez
- Moderator
- Posts: 12426
- Joined: Sun Sep 14, 2003 2:18 pm
- Location: Los Angeles
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests